the cause of the total dead injection motor and how to overcome it

Total Dead Injection Motor How come? Here's How to Overcome it - Motorcycles are one of the modes of transportation that have the largest number of users in Indonesia. Currently, various types of motorcycles have experienced a fairly rapid increase. Especially in the fuel section that previously used carburetor technology , developed into injection. With this fuel injection, engine performance can be better than the use of a carburetor.

Injection Motor Dies When On Gas

Although the development of motorcycle engines has been equipped with fuel injection, there are still obstacles that often haunt. Some of the injection motorcycle users still complain about the engine turning off when gassed. Whether in a state of being lit or just lit, the motor is constrained by the difficulty of gassing.

This dirt deposit can be the cause of the motor not being able to start. The presence of water in the fuel tank can also be the cause of the engine being difficult to start.

How to Overcome a Total Dead Injection Motor that is Difficult to Start

To overcome the condition of the injection motor that is difficult to start, there are several ways you can do. The first way is by heating the motor regularly even though it is not in use. This can prevent the engine from being cold for too long.

You can also warm up the motor before using it for long rides or long trips. This process only takes 30 seconds to 3 minutes. In order not to be in a hurry, take the time before departure and take a little time to warm up the motorbike.

The next way is to do regular service . In this service process, you can check the condition of the spark plugs and clean dirty spark plugs or replace worn spark plugs. And you can also drain the fuel tank so that all kinds of dirt or water that accidentally enters the tank can be cleaned. Cleaning the fuel tank can also make ignition smoother.

Injection Motor Can't Start

When starting the engine, sometimes the motor also experiences problems that are quite troublesome. Still just about to use it, the motorcycle is already fussy and can't be started. As an injection motorcycle owner, you must be disturbed by this condition.

Injection Motor Total Off

The worst condition is when the injection motor dies completely. It was confirmed that the fuel tank was filled, but the engine still wouldn't show any signs of life. So, what are the causes of the problematic condition of the injection motor in the engine ignition system like this?

Causes of the Injection Motor Difficult to Start

The problem of an injection motorcycle that is difficult to start usually occurs in the morning. After the motor rested for a long time, then was about to start it turned out to be cranky. Especially when we're in a hurry.

The cold injection engine engine can be the cause of the difficulty in starting this motor. The engine failed to make ignition. Finally the engine will not start at all.

Ignition failure can also be caused by the condition of the spark plug that his not suitable for use. Dirty spark plugs and spark plug that need replace are common causes of ignition failure. Although small, it turns out that spark plugs have a fairly important role in the life of a motorcycle engine.

Another factor that can also be a cause of engine failure and an engine that his difficult to start is the quality of the fuel used. Whatever type of fuel you use, it can build up deposite on the bottom of the fuel tank. Let's just that there is a difference in the amount of deposite created by the fuel of your choice.